ITI MCQ
Home
BASIC FITTING 2 DRILLING AND TAPER - Practice Mode
Categories
Machinist
BASIC FITTING 2 DRILLING AND TAPER
Practice Mode
1) Which way the coolant flows through the cutting edge in a drill?
Web
Land
Body
Flutes
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: Flutes
Question Details
1) Which way the coolant flows through the cutting edge in a drill?
Web
Land
Body
Flutes
2) Why the tap drill size to be calculated?
To avoid drill breaking
To avoid material wastage
To calculate sufficient cutting speed
To maintain sufficient material to tap
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: To maintain sufficient material to tap
Question Details
2) Why the tap drill size to be calculated?
To avoid drill breaking
To avoid material wastage
To calculate sufficient cutting speed
To maintain sufficient material to tap
3) What is an advantage of mass production?
Production rate is increased
Measuring time is increased
Jigs and fixtures are needed
Special purpose machines are needed
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: Production rate is increased
Question Details
3) What is an advantage of mass production?
Production rate is increased
Measuring time is increased
Jigs and fixtures are needed
Special purpose machines are needed
4) What is the disadvantage of mass production?
Production rate is low
Cost of piece is reduced
Jigs and fixtures are needed
Gauges are used to check the component
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: Jigs and fixtures are needed
Question Details
4) What is the disadvantage of mass production?
Production rate is low
Cost of piece is reduced
Jigs and fixtures are needed
Gauges are used to check the component
5) What is the reason for using dial indicator instead of scriber point in vernier height gauge?
To check eccentricity
For accurate marking
For accurate measuring
For good appearance
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: To check eccentricity
Question Details
5) What is the reason for using dial indicator instead of scriber point in vernier height gauge?
To check eccentricity
For accurate marking
For accurate measuring
For good appearance
Previous Question Set
Back to Question Sets
Next Question Set
Try Another Topic
Try Another Quiz