DRILL JIG - Practice Mode
1) Which is the important factor to determine the construction of fixture?
2) What is the purpose of setting blocks used in the fixture?
Explanation:
There are two main standards for wiring RJ-45 connectors for Ethernet networks: T568A and T568B.
The T568A standard, also known as the "A standard," has the following pinout:
- White/Green
- Green
- White/Orange
- Blue
- White/Blue
- Orange
- White/Brown
- Brown
The T568B standard, also known as the "B standard," has the following pinout:
- White/Orange
- Orange
- White/Green
- Blue
- White/Blue
- Green
- White/Brown
- Brown
Both of these standards are widely used, and either one can be used in a network. However, it's important to ensure that both ends of a cable are wired the same way, whether T568A or T568B is used. This is to ensure that the transmission is done correctly and efficiently, and to avoid any compatibility issues.
3) Which type of jig is used for awkwardly shaped work piece to drill at different angles?
5) Why two or four hold down slots are provided in the base plate of milling fixture?
Explanation:
CAT5 cable is a type of unshielded twisted pair (UTP) cable that is commonly used for Ethernet networks. The standard frequency range for CAT5 cable is from 1 MHz to 100 MHz, which is sufficient for most Ethernet applications including 10BASE-T, 100BASE-TX, and 1000BASE-T (Gigabit Ethernet).