ITI MCQ
Home
TURNING WITH LATHE ATTACHMENTS - Practice Mode
Categories
Turner
TURNING WITH LATHE ATTACHMENTS
Practice Mode
1) What is the name of work holding device were the irregular work could hold in lathe?
Face plate
Catch plate
B-Jaw chuck
Driving place
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: Face plate
Question Details
1) What is the name of work holding device were the irregular work could hold in lathe?
Face plate
Catch plate
B-Jaw chuck
Driving place
2) What is angle between the two faces of angle plate?
30 Degree
45 Degree
60 Degree
90 Degree
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: 90 Degree
Question Details
2) What is angle between the two faces of angle plate?
30 Degree
45 Degree
60 Degree
90 Degree
3) Which material is used to make angle plate?
Mild steel
Cast iron
Tool steel
Wrought iron
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: Cast iron
Question Details
3) Which material is used to make angle plate?
Mild steel
Cast iron
Tool steel
Wrought iron
4) How the roughness value is expressed?
Micrometer
Millimetre
Centimetre
Metre
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: Micrometer
Question Details
4) How the roughness value is expressed?
Micrometer
Millimetre
Centimetre
Metre
5) What is the roughnes value of grade No N1?
6.3 microns
0.025 microns
12.5 microns
0.4 microns
Show Answer
Report Question
What's wrong with this question?
Report
Correct Answer: 0.025 microns
Question Details
5) What is the roughnes value of grade No N1?
6.3 microns
0.025 microns
12.5 microns
0.4 microns
Previous Question Set
Back to Question Sets
Next Question Set
Try Another Topic
Try Another Quiz