LATHE ACCESSORIES - Practice Mode

1) Which part of the lathe gives perpendicular movement to the tool?

Apron Tailstock Carriages Cross slide

Correct Answer: Cross slide

Explanation:

The point through which the Whole mass of the body acts, irrespective of the position of the body, is known as centre of gravity (briefly written as c.g.). The plane geometrical figures (like rectangle, triangle, circle etc.) have only areas but no mass. The centre of area of such figures is known as centroid or centre of gravity of the area of the body. It may be noted that every body has one, and only one, centre of gravity.

2) Which part of the lathe is situated at right hand side of the lathe bed?

Carriage Tool post Head stock Tailstock

Correct Answer: Tailstock

Explanation:

3) Which lathe accessory is used to hold the previously bored job?

Face plate Drive plate Mandrel Catch plate

Correct Answer: Mandrel

4) What is the use of drive pin in drive plate?

Hold the job To rotate the job To turn the job To locate the job

Correct Answer: To rotate the job

5) Why the ball centre is used in taper turning by offset method?

Minimum wear and strain Minimum friction Economical Easy setting

Correct Answer: Minimum wear and strain

Previous Question Set Back to Question Sets Next Question Set

Try Another Topic

Try Another Quiz