DIESEL ENGINE COMPONENTS - Practice Mode

1) Which tool is required to remove the valves?

Torque wrench Valve spring lifter Box spanner Scraper

Correct Answer: Valve spring lifter

2) What is ovality of a bore?

Difference in dia measured top to bottom Difference in dia thrust to non thrust side of cylinder Difference in dia measured only at top Difference in dia measured only at bottom

Correct Answer: Difference in dia thrust to non thrust side of cylinder

3) When it is required to coincide the mark with timing gears?

During assembling water pump During assembling oil pump During assembling cam shaft During assembling radiator

Correct Answer: During assembling cam shaft

Explanation:

4) Which gauge used to measure the cylinder bore wearness?

Compression gauge Vacuum gauge Dial gauge Depth gauge

Correct Answer: Dial gauge

5) What is the purpose of the timing chain?

To connect water pump pully To connect alternator To connect crank and cam shaft gear To connect A/C compressor

Correct Answer: To connect crank and cam shaft gear

Previous Question Set Back to Question Sets Next Question Set

Try Another Topic

Try Another Quiz